YDL 3.7V 1000mAh 102050 Lipo Battery Rechargeable Lithium Polymer ion Battery Pack with PH2.0mm JST Connector

I had to put the battery in at a slight angle because it's a little on the larger side, but it works without any issue in my z.mote esk8 remote with the lighting and wireless charging mods.

Battery fits my Zmod remote, just perfect.

I had to swap the wires for my application, otherwise it's great powering my board.

The connector was on backwards on arrival. Not a hard fix, but annoying.

I installed this battery in the girlfriends Pokemon Go Ranger since the original will no longer hold a charge. Worked like a charm. Seems to be of good quality. Thanks

Works great for my drone.

Slightly bigger then I thought but pretty good battery.

I purchased this as the battery size would have been a good replacement for my Propel Flip 2.0 Drone. I had done a lot of research to match up the battery dimensions and this was even suppose to have the same voltage but higher mAh rating. (stock drone battery was only 750mah) I thought this would give me extended run time. Battery packaging was nice and it fit inside the drone battery case, but I did notice the wire gauge was extremely thin compared to my previous drone battery. Previous battery probably had 16 gauge wires.. these I would guess are closer to 22 gauge. In the end it was an unsuccessful experiment. Even though same voltage requirement and increased capacity the battery would only operate the drone for a few seconds and turn back off, not even able to lift off the ground.