TOTALFLOW 6644 Mini Race Exhaust Muffler | 304 Stainless Steel | 2.5" Inner Diameter Inlet - 2.5" Outer Diameter Outlet

The media could not be loaded. I painted mine with ceramic matte black. Works best when put within an exhaust system. 12 inches or more of pip afterwards for best results. 5/5 will buy again for another bike. Had this for a year now. I bolted mine with 5/16" self tapping metal screws cause ai have no welder. Tight fitting, Sounds 👍 👌

I have a 2020 Ford Mustang EcoBoost, and I put a 3” custom exhaust with SLP “resonators” on my Mustang about two weeks before I got this little resonator. To be honest, I wasn’t expecting much since my exhaust setup had quite a bit of drone on the freeway. I had my local exhaust shop install this resonator, and after they put it on and I drove it. I was impressed with the sound. It got rid of like 60-70% of the drone, and I still have that loud volume I love from my Mustang. But it’s not so loud that I can’t have a conversation in my car like before. Definitely scoop this up if you want a loud exhaust but want to eliminate most of the drone!

This item was very affordable and gets the job done.Build quality is really good also

These mufflers are well built and high-quality. Not spectacular but perfectly good. That being said, throwing these on a V6 sounds awfully sad. Serious drone.

Got them a week earlier than expected. Very high quality welds and overall feel. Can't wait to get them put on.

Put these on a Kooks true dual exhaust to take a little edge off of the cold start up and drone.Worked as expected, deepened the tone a bit, but cut back on the drone quite a bit.

Seemed to eliminate mostly all the drone and take it to a more reasonable sound level but after a few weeks of driving sounds like the drones back I might have an exhaust leak so updates to come.

I bought a 2018 Mustang GT with active exhaust, which sounded pretty good as is. But I wanted more of an old school muscle sound so I replaced the factory resonator with an h-pipe. Thay lowered the tone but made it a bit too loud for my taste and was raspy in the higher rpms. I bought 2 of these "mufflers" and put them in the middle of my h-pipe and I have finally achieved my perfect exhaust note. It brought it down a little deeper, took the volume down a smidge, and no more high end raspe. And with 304 steel I won't have to worry about them rusting out.One thing to note, one end is slightly larger than the other. I could fit one end perfectly over my 2.5 pipe, but the other end I had to butt up. No big deal but would have been way easier and more air tight sliding both ends together.