Hooke Road JL Mud Splash Guards Fender Flares Front and Rear Kit Compatible with 2018-2025 Jeep Wrangler JL Sahara Sport Sports (Exclude Rubicon)

Super value. I have two jeeps. I have OEM flaps on one, and these on the other. Both are made of the same material, have the same exact dimensions, and look the same except the OEM product has the Jeep logo. But at 1/4 the cost of OEM, Ill take these all day long. I highly recommend.

The media could not be loaded. After I removed the factory running boards from my Sahara and replaced them with step bars, I got a lot of gravel dings. These stopped that! Perfect finish and easy to install. Harbor Freight has the plastic rivet tool you’ll need for cheap. Thanks for a great product!

There are no instructions. The description says nothing about needing a rivet gun or the need to drill holes in the vehicle. Flaps should be labeled as to front and back.

The product is great. Works fine. However, I can’t believe that ANYONE would mass produce anything with zero instructions. If you aren’t quite handy, don’t buy these. They work and fit great but you need: a clamp to hold it while you drill, a drill, a 1/4” bit, plastic rivets, a plastic rivet gun, a sharp chisel or rubber removal tool…all to install these things.

Splash guards fitment is very good on my 2019 JLU Sahara and should do the job. A couple issues I have with these 1). The flaps have a rather large ridge around the inside, probably for stability, that I'm sure will hold dirt, mud and definitely snow and ice. It will be awhile before we see snow here in the northeast so I won't know how bad it will be for awhile. But I foresee a lot of snow and ice buildup. The other issue is the plastic rivet installation which may have been more difficult for me due to the cheap Harbor Freight rivet gun I purchased. It was just a bit of a pain. Also, there is one wheel well screw in back on each side that is removed/reused to hold the bottom of the splash guard. I found the splash guard did not fit nicely flush into the wheel well which made it difficult to get the screw started (too short). I had to jack up the Jeep to get enough room for leverage to push the guard flush with the wheel well to get the screw started.

These were super easy to install - yes you need to drill one hole on each front one - but it was simple.You do need a plastic rivet gun - the 15$ Amazon one worked fine. I would grab a trim pry bar for removing the old rivets if I were to do it again - but a razor blade and screwdrivers worked fine ultimately.

Look great and seem pretty ridged, great price and fit perfectly on my wife's wrangler sahara unlimited. You will need to purchase a plastic rivet tool to install these.

I bought these to keep the mud off of my doors. They work perfectly. They were very simple to install with the right tools. I did it myself while my husband was out of town. I am very pleased with them and would buy them again.