No Solder - Permanent Repair - Replace Surface Mount Components Without Using Solder - Non-toxic If you've ever tried to replace a surface mount part without specialized soldering and desoldering equipment, you know it's next to impossible. But Surface Mount Component Fix will allow you to glue parts in easily with its special conductive glue formulation. Great for Computer Motherboard repairs. These are tough, flexible wear-resistant repairs.
J**
Works but application approach needs to be rethought
It does the job it's kind of messy to work with which innocence discounts the whole difficult to deal with soldering and desoldering traditionally. I think it would be very wise if the manufacturer put this into a injection type container or perhaps even a bottle with a dripper or something that makes it easier to just pinpoint right onto the spot rather than trying to dip a wooden stick into the mixture and place it on a board in very tight tight spaces this makes it a little difficult especially because it is very runny even after heavily mixing it so be prepared to have drops dripping everywhere. Also when you open it be very careful it's a very full and has a tendency to spill out everywhere
R**F
Didn't work for my application
My GMC SUV has an antenna built into the side windows. The side mount, a plastic case with the metal connection inside came off and it had some kind of adhesive on it that had apparently worn out. I followed the directions and put some of the glue on the connection and taped it down with a few layers of tape to insure the glue would stick and to increase the compression and dry time. It is also summer so the heat in the vehicle should have helped it along but it didn't work. I have yet to figure out a way to fix this. The antenna in the glass is a good idea until it isn't.
Trustpilot
2 months ago
1 week ago
