DuBois 51009 Aluminum Miter Gauge Fence with Tape Measure Right to Left 16-1/2”

Square! I put this in my older Craftsman 113. The fences on these are crummy, but the miter gauge not too shabby. I really only care about 90 degree cuts with it, and it holds that solid. This fence bolted right on, though 1/4 20 was too fat for my slots. 10 32 (don’t laugh if I’m off on that) fit just fine. The ruler reads to the left, and the unit is very nice for the 22 bucks in the fence and about 12 for the stop. My cuts are dead on. Very pleasedThat’s a PowerTech 2.25 flip stop. Also very solid, no deflection.

Great quality for the money. Very accurate and slides smooth on my DeWalt table saw. Works perfect right out of the box.

Glad to be able to buy Taiwanese rather than Chinese in todays global climate. Gauge is lightweight, but very impressive in build quality. Only needed very minor adjustment to get square.

I purchased this miter gauge for my Dewalt DWE7485 to replace the cheap miter gauge the saw came with and I am very pleased. This is not the most expensive or fancy miter gauge you can purchase but for a 300 dollar table saw, this is a great 50 dollar upgrade. There are a few quirks but for the money, this is a great miter gauge. I would not recommend purchasing the aluminum fence option. I used a hard piece of sacrificial wood and it works perfectly and the miter gauge cuts square on straight or angle cuts.

Even though I'm returning this item, it was solidly built with great features. I just wish it fit my older table saw (that doesn't have standard miter slots)

This thing is pretty nice! Has nice adjustment for in t slot slop, moves freely and comes with hardware to add a fence

VERY NICE MITER GUAGE COMPARED TO WHAT CAME WITH MY SAW..LIGHTWEIGHT MADE MOSTLY OF ALUMINUM..WORKS GOOD HAS A DECENT SIZE HANDLE ..PLUS IT FITS NICE IN MY SAW AND IS ABOUT THE PERFECT LENGTH

It arrived missing some parts as Amazon had slapped the shipping label on the retail packaging and no extra tape to seal it shut. I am missing the handle and some bolts etc but the basics are here to make it usable. It looks well made and the angles index nicely.Moot point I guess as it doesn't fit the slot by about 0.016" too wide. Looks like it may be made for a metric saw. The slider is not machined, just the plain aluminum extrusion.Not sure I want to bother machining the slider down. Another reviewer mentioned they did that but then it wobbled in the slot. If I machine it I cannot send it back if it wobbles in my saw.