PIT66 Clear 3rd Third Brake Light, Compatible with Ford F150 Truck 2009 2010 2011 2012 2013 2014, High Mount Stop light Tercera luz de freno

I have a 2004 F-150. When i took off the old light housing noticed that the connector was not accessible. Even gently pulling on it. I searched a popular video share site to get help and found a great video which i cannot post here. As an over-60 woman was impressed that i could take care of making that connector more accessible. Basically you do need to access the space from inside the truck. A small pry bar to pull off the two circular plugs on the very back ceiling panel. Gently pull down to see the connector. My connector was anchored to a subframe, again using the pry bar carefully - i was able to dislodge the connector and push it outside through the hole. Connection was perfect. Reverse to replace the ceiling panel usually just pushing the plugs in by hand or tapping with a soft mallet (make sure you finish connecting first, my wire was not very long and had to hold on to it while disconnecting and connecting). As other reviewers have said, it does fit perfectly, comes with a gasket and actually looks/works like a factory install.

The wire harness clip included with this light was useless as my vehicle had a completely different set-up: wires went directly to each light. I cut the clips off and hard wired them in. The hardest part was getting the old factory tape off the brake wires because I didn’t have much to work with. The cargo lights had plenty of slack. The neutral on my truck was all black, power to the cargo lights was black with a white stripe, and the brake light was green. I matched black to black on the new light, black with stripe to blue, and green to green. I attached the included seal directly to the new light before wiring and I used my old mounting screws. This worked perfectly for me.The brake light wires were the problem because of length. I wish I had a quick connect ready for those.

Why did you pick this product vs others?:It's great and easy to install. For other F150 owners looking to install.... Look deep into the hole where it fits in. There is a plastic peg clip that holds the wire and is pegged into the body. Take a long flat head screwdriver and hammer. Bust that clip out and the wire plug will fully come out. Some video tutorials suggested to remove the roof cover on the inside..... Don't do it.

Great product was plug and play came with bulbs fit perfectly price was really good looks great on my 06 f-150

quality ok, test before installing.cheap light bulbs 2 were bad.

Looks good, bright, and stops the leak I had before.

Exelente muy buen producto y entrega rapida mil gracias.

Poor quality control, this light has mounting holes for three bulb sockets, they are intended to be inserted and rotated a quarter turn to lock. The key holes used to accept the locking fins are not sized correctly for the fins. The result is that the bulbs cannot be attached, and therefore this product is useless. I am aware that the fins are not all the same size, and I tried all orientations before leaving this bad review. The chrome paint job on the reflector is flaked and extremely inconsistent. It looks like the junk that it is. Now I have compromised the factory seal on my truck, and this cannot be installed to replace it. Where is your quality control? Does nobody check to make sure the product works before you sell it to me saying that it works? Now I have a new risk of leaking water into my cab because this company can't be bothered to do their job. Unfortunately now the financial burden on me to fix it may be higher than the supposed value of this junk.