Eaton WD1212 50-Amp 3-Pole 4-Wire 125-Volt Surface Mount Range Power Receptacle, Black

Bought this to use on my RV power cord reel. It was much easier to wire than the replacement 50 amp plugs commonly used. I was not worried about it not being waterproof since it is installed in the electric bay and protected from the elements. Now I can easily install my surge suppressor in the electric bay and not leave it out visible on the power post. And if for any reason the surge suppressor stops working I can just unplug it and plug my transfer switch into it.

Super fast shipping. Well packaged and cheaper than my local big box store

I bought a 240V extension cord from TechnoRV but the receptacle end was overheating due to poor continuity. The wires were poorly connected to the receptacle. TechnoRV has seriously limited “warranty” and in all practical sense, did not back their products. Luckily, I found this receptacle, lopped off the original one and connected it to the extension cord. It has been performing flawlessly since. No more overheating, and therefore, no more error codes from the mobile connector for my EV.

It makes a nice strong connection to the prongs of the connector. The screws that clamp the wire could be a little beefier but for $8 I can't complain too much. I would order this one again without hesitation.

Seems like a good product. Was easy to install. The only things I have questions on are the wire clamp, the single screw for the plastic hood, the screw terminals, and the neutral terminal. The wire clamp is screws to the outside of the box, but so far it seems to have kept up as an extension cords end. There is only one screw holding the front case to the back, so the part where your wiring goes may seem a little loose. The neutral screw is the tallest and works great for six gauge wire, but will be too high to mount the plastic case if you are a larger wire size.The screw terminals push the strands of stranded wire to the side, and seem like they are built for solid core wire. Other similar products use a brass plate to spread out where the screw pinchs the wires so that they have better contact.

I wanted a brand name plug and this one met expectations. Connections we're solid. Plastic housing fit well. All good.

Much better built than the competition and less expensive too. Cable clamp means that you can use this for an extension cord or a wall mount. My application was to mate it to a crow foot plug as an adapter. A ready made adapter would run $100 more than the components and this way, you know what you are using is built right. Cooper stuff is easier to use because it has better engineering and construction. The fact that it costs less is an added bonus and confirms the conclusion that using Cooper is a no-brainer!

Unlike some other similar outlets, this one is relatively easy to install, and seems safe too. Of course suitable only for places that will never get wet.

Needed a 50 amp receptacle for my welding unit. Knowing Cooper is a well established manufacture of electrical devices, ordered this part and installed under my sub-panel in the garage. No issues and delivery was very prompt. Would not hesitate to order again, if it was required.

mount was easy to install, price was good, so far seems pretty durable. This is NOT a waterproof unit so it is only suitable for indoor/garage installation.

Utilisés pour mon véhicule électrique comme rallonge. 40A aucun problème

The connector is very ruggedly built, the total opposite of flimsy. I am using it for an extension cable for my EV charger. Highly recommended.

I used this to convert a dryer cable that I had to a Nema 14-50 plug for my Tesla Model 3. I wasn't able to find one of these at the big box stores. Amazon always has the stuff I can't find in the stores and the price was good. I can plug into a dryer outlet and then plug in my Tesla mobile charger. This will give me 24 amps for charging.