6PCS Hollow Leather Hole Punch Set (1.5mm-4mm) for Belts, Watch Bands, Leather Craft, Round Hole Punch Tool for Belt, DIY, Leatherworking, Repair Tools -ASONTAO

I am so glad I chose these over the squeeze type rotational hole maker. I saw some comments about how challenging they can be to use. This was my first time using a belt hike maker and could not be happier with the results. Be prepared to do some tapping with a hammer and make sure you are on a surface you will not damage. I did it in a countertop with a small notebook under it so as not to chip the counter. The most challenging part will be lining up the holes. Making the holes is easy. You will be doing some tapping. But I was also being cautious not to damage the marble countertop. If you are on a nice solid work bench you may be able to just give it two or three good sacks.Place the hole punch on the good side of the belt. Here is a a tip on how zI got the holes lined up:Get several thumb tacks and place them in the holes already there with points facing up. Get a piece of paper and line up the edge to the edge of your belt and press so that you make a perfect template of exactly the positioning of holes. Then move the paper down with the edge lined up to she of your belt. Place the paper over the last two thumbtacks yo keep it stable then use a pen to mark out the spots on the paper where the thumbtacks made holes. (I hope this all made sense). Now you know exactly there the new holes should be! I made these marks on the underside of the belt but you do not have to. Then I took a utility knife and twisted it around and around over the pen mark till it just whet through the belt. This did not make the hole I wanted but it did go through to make a pinpoint on the good side of the belt so I knew exactly where to make my holes. But you can just use the template paper to mark your holes with pen on the good side. Just of course be careful not to slip and make an off mark, especially if the belt is light color. The process was actually easy and kinda fun!

These have been the key to a number of beginner leather projects lately. It's really nice to have a variety of sizes available for the different hardware I've been using and these are better quality than the punches that have come in other kits.Just make sure you use scrap wood or some safe surface underneath for when they cut through the leather!

A selection of different diameter hole punchers, which make it easy to add an extra hole to your belt (both ways 8-) ! I was a little surprised how small they are, needed the largest for mine. Used a piece of wood under the belt and a regular hammer to hit the punch. As easy as that!

They but hole in leather that want I got them for

These are smaller than I thought but that’s my fault for not reading the sizes. They seem like some nice punches and I’m definitely keeping them.

These were very sharp and took a Lott of effort to add a hole in a belt. Plus side is they were cheap and easy enough to sharpen with a file.

Correct tool for the job.Easy to use.A keeper

The product worked just fine

Worked just as promised. I used it to cut vinyl.

The largest punch is OK but I would have liked one just a little larger.

nice product good delivery

J’ai acheté cet outils pour faire des trou de ceinture de cuir. Après 3 ou 4 trou l’outil était déjà déformé