Heater Blower Motor Fan for 1989-1995 Toyota Pickup, Toyota MR2/Tercel/Paseo/T100/RAV4, 1990-2005 Mazda Miata, Mazda MX-3/323/Protege, Mitsubishi Expo/Montero/Expo LRV, Eagle Summit 87103-42020

Fit my 1994 Toyota Pickup perfectly.

Installed and operating well

Got this for my 2002 Miata SE. It fits like OEM, BUT the shaft that the fan spins on is a bit taller than OEM and prevents the recirculate flap from sliding over. Be sure to check this before screwing everything back in - you might have to cut the top of the shaft off like I did (I used a dremel tool). Other than that this seems like very good quality and it's quiet.

Worked perfectly

For my 1991 Toyota pickup 22RE 4WD The shaft protrudes a good half inch passed of squirrel cage which prevents the vent for recirculating air to not close you have to cut that half inch off .... i used bolt cutters then grinded down to make it flush/even ...three bolts that u have to remove...you have three options an 8 mm socket, common screwdriver or a 25 Torx and the very back bolt is very difficult to get off I like to never got the new cage in ...however it works very well

Perfect replacement for my 31 yo Yota. My only issue was the motor shaft was a 1/4" too long and my recirculate door would not close , I had to take it back off and grind the end off the shaft now it works perfect

What was shipped was not what was shown in the photo. I installed this oin a 1990 Mazda Miata and everything went great, the plug was the same, the physical mounting dimensions are the same, but the center metal rod that's in the middle of the fan extended too far past the round fan blade and blocked the recirculation flap in the car from fully opening and closing. I had to take an angle grinder and trim off about 1/4in of metal to make the flap clear.

My previous fan from a different company crapped out after a year. This replacement went into my 99 Mitsubishi Montero base. My air now blows hard and cold.