BELLEZE 48" TV Stand with 18" Electric Fireplace Heater, Modern TV Stand for TVs up to 50", Entertainment Media Stand with Open Shelves and Storage Cabinets for Living Room, Bedroom (Ashland Pine)

We purchased the Belleze Norrell 47" TV Stand (Item #: 014-HG-41802-ESP) to go in our living room and sit under our wall mounted 65" Ultra HD TV. We specifically chose this model for two reasons. One is that it comes with the fireplace option, which gives the room a very warm and cozy feeling. Two I liked the amount of area in the top for components as it stretches alk the way across the entire cabinet. Room enough for everything I wanted to attach to the TV for this room. It was not difficult to put together for the most part, but there were a couple of items that should have been put on while everything was apart that would have helped tremendously. First there are two small metal plates (E) with screws (F). They hold the front middle piece together with the sides, parts (9) and (10). They really should go together while the pieces are separate because once you put everything together they are really hard to screw together and since its up in a corner on both sides there's not a lot of room to maneuver in. Even if you just put it together and then losen it, it would be easier to assemble after you get everything together. The other thing that would be easier is to attach the hinges to parts (7) and (8) while they are apart. Once again it's very difficult to get at the top and bottom screws that are up against the corner when it is assembled. Once in place you can loosen them while you put the doors on and then tighten them. Its very difficult to install them while the unit is standing up. Finally you need to pay close attention on pieces (4) and (5) to make certain that the finished side faces the front, and pay attention on pieces (9) and (10) to make certain that the front pieces (11) and (12) go the right way. It's the one area where the picture kindof shows you the right way, but it's not overly clear. Parts 9 and 10 are flat with a perpendicular edge on one end. Parts 11 (which attaches to 9) and 12 (which attaches to 10) need to sit flush on the same side where the there is a lip from the perpendicular piece and face the other way. The little holes on the sides of 11 and 12 must be opposite of the big holes on 9 and 10. Those holes on 11 and 12 are where the cross piece (13) attaches.That was the only real sets of gotchas. Once assembled it realky is a beautiful piece and it has real hardwood mixed in with some particle board. I highly recommend purchasing this TV stand. We are very happy with it.

This is a TV stand in my living room that I hope to use to heat my living area in the winter.I have not tried the electric heater yet, b/c it is hot in Texas right now. I was able to put it together myself using just a Phillips head screwdriver.I did not attach it to the wall for “anti tip” protection, because I have no pets, nor children that could accidentally pull it over on themselves.

I initially purchased the first console for our upstairs loft to create a cozy atmosphere (see image with it being used as a TV console). Meanwhile, I was trying to find a cost effective way to create the appearance of built ins on either side of my living room fireplace. It turned out that the dimensions of this console were perfect and I could choose from a variety or colors that would best fit my decor. In addition to it being a great decorative addition, they are extremely easy to put together - which is fantastic because I am not that handy!

It’s a beautiful piece overall. Would I buy it again? Possibly. It was very hard to put together alone. Took 5 hours. The worst part was noticing that there was damage on the top part. I messaged seller so I will update once they respond. It’s great quality and sturdy. It’s small but perfect for my two bedroom apartment. It looks more expensive than it is so that’s very nice. I will say that a drill is useful putting on back paneling as they have no pre drilled holes in the back.

The media could not be loaded.  Using an electric screw driver and at times a old fashion hand driver, I put this together in about an hour, maybe a little over. I turned it on, sat back, and was immediately impressed. The heater is super nice , the fire looks great (is dimmable with 4 settings) and it feels really sturdy.I'm impressed , it's exactly what I wanted for a really good deal on the price

This was easy to put together. Very sturdy! Makes me feel so cozy! Love the fact I can turn it on without the heat.

This product is perfect and looks great in our living room. Everything works well. It took about 1.5 hours to put together, but it wasn't hard. Love this fireplace stand and definitely recommend purchasing it.

Debated on getting this for awhile, and finally pulled the trigger. Put it together by myself and took alittle over 3 hours. Laid everything out before hand , but heads up....the box is extremely heavy, so I had to open it where FedEx left it and carry all the pieces inside.I ABSOLUTELY LOVE IT!!!! My living room was at 64 degrees when I got home from work, this heater going had it up to 70 in about 45 minutes. The fire looks realistic, I love the rustic gray color, the remote is a good little feature too. I had to run and get a pack of small sliders to put in the bottom to move it across the carpet to set it in my corner spot. I am EXTREMELY HAPPY with this purchase and recommend it if your looking for one.