WMYCONGCONG 10 PCS Joystick Breakout Module Game Controller compatible with PS2 Arduino

Great Item and Service

Joysticks are fine and work well. They come individually bagged in a cardboard box. Ignore the picture of them in a plastic container, you ain't getting it.

Absolut NICHT zu empfehlen. Die Dinger sind nicht zu gebrauchen. Wie einige schon geschrieben haben... Bewegt man den Stick nur um ein paar Millermeter, geht er sofort auf 0 Ohm... Bzw 10k. Man könnte meinen das Ding funktioniert Digital und nicht Analog...

Well packed. Tested in my robot project. Works great. Packaged individually in a static resistant plastic bag and all ten are placed in a card box. Delivered earlier than expected and promptly. Will recommend to others and will buy again.

Die Range in der sich die Joysticks bewegen ist eine Katastrophe. R = 4,7kOhm Mittelstellung liegt bei 3,3kOhm, sobald der Joystick um 1-2 Grad bewegt wird wechselt R auf 0 bzw 4,7k Man kann sie so wie sie sind direkt in den Müll werfen.

I'm not sure why some folks are having issues getting a smooth sample of values across the stroke of the joystick's axis. It is important to note these are not intended to be maxed out to extent position anyway. You can only move about half way or a little more to the edge before it is overwhelmed. So perhaps people are just not moving slowly. Got me. But here is some code I used to test mine with. No issues. I hope this helps someone... /* micro joystick test sketch / atomkey 2019 doesn't test for the push button feature - that's simple ~does test for the analog read on the x and y axis I coded this for folks that have said there are only three gradations of measure they can get. This runs fine on my Arduino and generates a smooth gradation from 1024 max to 512 center and then to 0 minimum. Keep in mind the joystick isn't intended to be moved to its extreme extents. The boundry is not at the outer edge. 4 wires from the joystick to the arduino 2 for the axis 1 for the ground and 1 for the +5v */ int sensorPinX = A0; // input pin joystick x axis int sensorPinY = A1; // input pin joystick y axis int sensorValueX = 0; // variable x axis int sensorValueY = 0; // variable y axis void setup() { Serial.begin(9600); } void loop() { // read the x,y values from the sensor: sensorValueX = analogRead(sensorPinX); sensorValueY = analogRead(sensorPinY); Serial.print(sensorValueX); // show results Serial.print(" "); // on serial monitor as Serial.println(sensorValueY); // two columns of data delay(150); // for even smoother (stable) results you can perform a // mean sample run. That's where you sample the signal // n times over t seconds and take the average of the reads. }

I am using these for RC remote building. So far they are working pretty well. I am not use the range is all that linear, but they are working just fine at this point.