Supreme Suspensions3" Front Leveling Kit for Dodge Ram 1500 2500 3500 High-Density Delrin Coil Spring Lift Spacers 4WD - Can Cooler Included with Purchase

I finally got around to installing these. They were easy to install and work perfectly! Instructions were good! I did use a spring compressor. This made it much easier. I did disconnect the sway bar. Make sure you have the axle supported or you will get a surprise! If I had raised the truck higher, I would not have needed the spring compressor! This is a good product and made well! It is not plastic, it is delron, which is a much stronger and much used product!!

This is an awesome product!!! I have a 3inch on my 2010 dodge cummins. The installation was very easy and went smooth, the finished product looks and functions better that any other leveling kit I've ever uses!!! I don't say this about many products so I hope this helps I would recommend it to anyone! Cole,

Would have been nice to have some instructions, not that I needed them but I'm sure someone might.

Shipping was on time, says no special tools required 2 hour install and able to reuse old shocks. First off I had to purchase coil spring compressors and I had to use a bottle Jack to push the front axle far enough down too fit the 3" block and the shocks are 1.5" too short so you are gonna have to buy new shocks. Other than that lift picked up my truck considerably and I am able to run a 37 with minor trimming

Fast shipping. Lifted the front of my 98 Dodge ram 2500 to perfect height, truck sits level now.

Seems like easy installation at first but its not as simple as the instructions lead you on to think. They tell you to drop the axle and pop the coils right out but to actually get the spacer to fit you have to get a compressor and reduce the coils about 4 inches to get enough clearance. Also grade 8 hardware is included in the kit which seems good until you go to bolt it up and the nuts aren't even the right size to fit the bolts. Plastic is suppose to be strong but you tighten the nuts to "recommended" torque rating and it cracks and then you have no way to hold the shock tower in place unless you take the coil out and put a new bolt of your own in which is a pain in the ass. It kinda got the job done other than the headache and cheap manufacturing aspect.

The same day I installed these spacers on my 2006 Dodge Ram 3500 pickup I noticed these spacers began splitting apart where every bolt went through the composite material (not steel). Please note there were no torque specs included with this product other than "be sure all bolts are tight"? After several hours installing these spacers and then several more hours removing them, I was very disappointed. I would encourage anyone wanting to lift or level the front of your pickup spend the extra money and install new coil springs instead. However do NOT install Skyjacker D30 coils as some websites recommend for a 2" leveling kit. I did after deciding against spacers and D30's did not raise the front one inch on my 2006 Dodge Ram 3500 4wd. I do not like leaving negative feedback, however due to the potential danger involved due to possible part failure I felt obligated to share my experience. I rated the product using one star because that was the lowest review I could post.

Nicely built product that doesn’t effect the ride, went in pretty easy and looks good